湘ICP备12008303号 OKE Precision Cutting Tools Co.,Ltd. E-mail:Info@Oke-Carbide.com
2020-04-20
FM90 square shoulder milling cutter
Maintaing good perpendicularity at large cutting depths action
6 cutting edges give high economical efficiency
Cutting edge wiper gives good surface quality
Suitable for P M K materials
Suitable for: face milling, square shoulder milling, slot milling
Responsible editor：http://www.oke-carbide.com
2020-04-20
Flying Stream series——New chip breaker for stainless steel cutting
Flying Stream series——New chip breaker for stainless steel cutting
【PVD NEW GRADE ON STAINLESS STEEL】——OP1515
The Carbide substrate with uniform fine grains has very good edge strength and general performance，
The New PVD coating technology obtain a outstanding wear resistance, excellent thermal stability, chemical stability and adhesion resistance,
Suitable for all kinds of ISO M and low-carbon steel with continue and interrupt condition in low speed
【Semi-finishing ISO M material】——KMM
•Double rake angle design ，the cutting edge is more sharp and impact-resistance
•Variable cutting edge width design guarantees good sureface and restrain groove wear
•Compare with OMM and MF ，suitable for all kinds of semi-finishing and finishing ISO M
Responsible editor：http://www.oke-carbide.com
2020-04-20
Sharp cutting edge design ，cutting quick and smooth
Smooth cutting edge treatment，high surface finish.
High quality substrate，good universality
Sharp cutting edge design ，cutting quick and smooth
Smooth cutting edge treatment，high surface finish.
High quality substrate，good universality
1、Reasonable chipbreaker design guarantee the chip-flowing well and high surface finish.
2、Sharp cutting edges structure combined with high toughness 、high wear-resistance and strong university carbide substrate makes the inserts cutting edge tough.
3、high wear-resistance coating makes the inserts with good applicability and universality.
Responsible editor：http://www.oke-carbide.com
2020-04-18
FM45 face milling cutter
8 cutting edges on double sides
Curved cutting edge design
Effectively reduces cutting forces
Sharp edge generates low cutting force
Cutting edge wiper gives good surface quality
Responsible editor：http://www.oke-carbide.com
2018-07-24
OK6110
A material with both abrasive resistance and toughness, It's the first recommended grade for turning tools . It's suitable for semi-finishing and finish of carbon steel, alloy steel .
OK6120
It has good toughness, thermal shock resistance and wear resistance. It's suitable for turning and milling of steel, especially for applications where requires high toughness.